Chair Cane
Shop Now For Quality Chair Cane Materials
Use cane webbing for chairs that have a groove around the perimeter of the chair, as shown at left. This is also called “sheet cane” and “pressed cane”.
1 running foot of 24″ cane webbing is 12″ x 24″.
1 running foot of 18″ cane webbing is 12″ x 18″.
2 running feet of 18″ cane webbing is 24″ x 18.
SIZE of cane webbing pattern is the measurement from the center of one hole in the pattern weave to the center of the next hole in the pattern weave.
Allow extra width for the cane webbing that will go into the groove and extend out around the spline. This is usually 2″ extra for each of the FOUR sides of your chair seat. If your seat is trapezoid shaped, be sure to measure from the widest part of the seat. 2″ + widest part of seat + 2″. Then 2″ + from to back of chair seat + 2″.
Example:
a 14″ cane webbing seat requires : 2″ + 14″ + 2″ across the width, 2″ + 14″ + 2″ front to back. Size of cane webbing KIT to Order: 18″ x 18″.
OR, without a kit, order 2 running feet of cane webbing + spline + wedges.
18×18 Cane Webbing Kit 1/2 Fine
Your package will include ONE 18 x 18″ piece of traditional hexagonal cane webbing in 1/2″ fine pattern for a chair with a groove, ONE package of 5 wedges, ONE 6 foot coil of spline, and easy installation instructions.
Spline #8, 3/16 in wide 6 ft
#8 Spline for a 3/16″ wide groove. To be used with pre-woven cane webbing. 6 foot coil.
24×24 inch Cane Webbing Kit 1/2 Fine
Your package will include ONE 24″ x 24″ piece of traditional hexagonal cane webbing in 1/2″ fine pattern for a chair with a groove, ONE package of 5 wedges, ONE 6 foot coil of spline, and easy installation instructions.
Caning wedges, set of 5
Caning Wedges. Used with cane webbing projects to tap in the cane. Set of 6.
